With the widespread use of electric hoists and low clearance manual hoists, understanding the starting and operating principles of electric hoists is crucial for efficient and safe operation. Below is an introduction to the starting and principle of electric hoists:

Starting of Electric Hoists

The starting of an electric hoist typically involves the following steps:

Power Supply Connection: Ensure that the electric hoist is properly connected to a power supply. This usually involves connecting the hoist's power cord to an electrical outlet or a dedicated power source.

Control Panel Operation: Most electric hoists are equipped with a control panel that includes buttons or levers for lifting, lowering, and stopping. The operator uses these controls to initiate the hoist's movement.

Motor Activation: When the operator presses the lift or lower button, an electrical signal is sent to the hoist's motor. The motor then activates, providing the necessary power to drive the hoist's lifting mechanism.

Brake Release (if applicable): Some electric hoists are equipped with brakes that need to be released before the hoist can move. This is usually done automatically when the motor is activated, or it may require a separate control action by the operator.

Principle of Electric Hoists

The operating principle of an electric hoist is based on the conversion of electrical energy into mechanical energy to lift and lower loads. Here are the key components and their functions:

Motor: The motor is the heart of the electric hoist. It converts electrical energy into rotational motion, which is then used to drive the hoist's lifting mechanism.

Reducer (if applicable): In some electric hoists, a reducer is used to decrease the speed of the motor's output shaft while increasing the torque. This allows the hoist to lift heavier loads at a slower, more controlled speed.

Drum and Wire Rope: The motor's rotational motion is transmitted to a drum, which winds or unwinds a wire rope. The wire rope is attached to a hook or other lifting device, which is used to lift and lower the load.

Brake System: Electric hoists are typically equipped with a brake system to prevent the load from descending uncontrollably in the event of a power failure or other emergency. The brake system may be mechanical, electrical, or a combination of both.

Control System: The control system of an electric hoist includes the control panel, electrical wiring, and safety devices (such as limit switches and overload protectors). These components work together to ensure the safe and efficient operation of the hoist.

The main equipment produced by Hebei Makita: stage electric hoist, electric chian hoist, wire rope electric hoist，Hand chain hoist, lever hoist, pneumatic hoist and other lifting equipment